| Thread Tools |
| This thread is privately moderated by birdofprey, who may elect to delete unwanted replies. |
|
|
|
Thread OP
|
Discussion
CNC UAV/FPV and ODR parts
Just some of the UAV/FPV and ODR wing parts being cut on the CNC Router. Nothing major, just helps make much more accurate and higher quality parts. www.EdgeRC.com
|
|
|
|
|
|
|
|
|
|
Cool stuff Justin..
 I didn't know you had a CNC. 3d capabilities ?? Tim |
|
Latest blog entry: More colours
|
|
|
|
|
|
Thread OP
|
Yup, part of the re-tooling and re-starting. This provides more flexability in our designs. Allowing a total departure from foam. And yes, 3D up about 6 inches deep and 48x48 inches.
|
|
|
Last edited by birdofprey; Nov 28, 2012 at 04:30 PM.
Reason: added info
|
|
|
|
|
Thread OP
|
Also have a 4th axis (rotating) making it 4D so to speak.
|
|
|
|
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion | Chrisbrit81's FPV Raptor - UAV Grey | Charlie-RC | Your Plane Photos | 5 | Nov 15, 2016 09:48 AM |
| Discussion | HobbyKing FPV / UAV Fiber Glass Kit V2 (With Flaps) Setup | FeWolf | Beginner Training Area (Aircraft-Electric) | 7 | Nov 13, 2012 06:17 AM |
| Discussion | Hobby King FPV/UAV V2 or EPP FPV? | onboardtherc | FPV Talk | 7 | Mar 19, 2012 10:19 AM |
| Sold | FS: Axe CP CNC parts/motors/stock parts & Trex 450 CNC tail blade holder | jrmotorsports55 | Aircraft - Electric - Helis (FS/W) | 6 | Nov 09, 2008 08:27 AM |