Joined Oct 2014
Fr Sky taranis x9d plus radion
I am needing some technical support for my vector. I have a fr Sky taranis x9d plus radio and receiver. I am so lost on how to configure them to work together.
The. Receiver has 8 channels with sbus & rssi inputs.
Not sure how to configure this option. The ail is plugged in the sbus. Ch1 throttle, ch2 empty, ch3 elv, ch4 rub, ch5 mode, ch6 aux. signal wire rssi from receiver to rssi port on vector. 5v power from vector to ch8 just ground & power to power receiver.
How to configure the radion and map out the switches for flight modes?
There is only 2 page manual for the taranis radio and that was not much help. I have been looking for days trying to get this configured to work with out bugging you guys but I am stuck. Please help if you can.
Joined Oct 2014
I have a specktrum 6 channel radio but I needed more channels to setup a eagle tree vector so I bought be the new FR SKY Taranis X9D Plus Radio.
I must admit first I am over whelm with this radio and how to configure it.
I am hoping someone would be kind enough to help me configure this radio to map out the switches and setting.
The radio came with the X8R receiver that has rssi & sbus features.
I am confused about how the Telemetry can be setup and how it works.
The receiver has port 1-8 a sbus port & rssi port
The vector has a Ail wire label Ail/Sbus so instead of plugging the Ail in to port 2 on the receiver I plugged it in to the sbus port
port 1 = throt
port 2 = empty
port 3 = elv
port 4 = rud
port 5 = mode
port 6 = aux
port 7 = empty
not sure if this is correct or not.
I am setting this up for a quad so it does not have any servos.
port 8 = only power/group cable, no signal wire going to the vector PSU 5v out supply that normal goes to a camera.
This is to power the receiver.
I do not know what to set the fail safe as. I have it set at no signal option in the radio.
When I run the transmitter wizard to get the vector to talk with the radio it wants a see the fail safe enabled. It will not let me go any further in the wizard setup and have to cancel because it does not see the fail safe.
I also need help to assign a channel like SA the three position switch to set all the way up is off, middle 2D, all the way down 3D flight mode.
And to set other flight mode to other switches.
any help would be great!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Fr SKY - TARANIS X9D PLUS Transmitter/Case, Mode 2 (No Receiver)||CE37||Aircraft - General - Radio Equipment (FS/W)||6||Nov 17, 2015 10:15 AM|
|For Sale||Fr SKY - TARANIS X9D PLUS Transmitter, Mode 2 Without Box/Case||Sundrop||Aircraft - General - Radio Equipment (FS/W)||1||Sep 09, 2015 10:28 AM|
|Sold||New Fr-Sky Taranis X9D with Perfect Case plus RX||ZIIguy||Aircraft - General - Radio Equipment (FS/W)||1||Sep 06, 2014 11:07 PM|
|Sold||Fr SKY Taranis X9D w/Orange DSMX /DSM2 module||Wing&aPrayer||Aircraft - General - Radio Equipment (FS/W)||1||May 08, 2014 07:23 PM|