Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Feb 23, 2013, 11:04 PM
Guntar is offline
Find More Posts by Guntar
Registered User
Joined Jul 2012
49 Posts
NAZA Controller with Turnagy 9x

Guys, i need help. Setting up NAZA controller with Turnigy 9x TX, i also upgraded Turnigy with FrySky module.
This is what i am running in to: throttle is outputting signal to two channels (channel 3 on receiver and T on Naza and channel 6 on receiver and X1 on Naza)
This is new setup in TX no mixing or any other con-figs have been done. I tried two receivers, the same thing. When it's doing this i cant use channel six for anything.
Can someone point me to what can be setup wrong.
Guntar is offline Find More Posts by Guntar
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Turnigy 9x with DJI Naza Problems with channel 5&6 for lights sgtraven Multirotor Electronics 1 Jan 11, 2013 10:15 PM
Discussion 9CH Turnigy 9x simple control 3-position switch setting and the Naza + GPS raayd Multirotor Electronics 0 Nov 11, 2012 01:48 PM
Discussion NAZA GPS Failsafe with turnigy 9X and ER9x brifa Multirotor Electronics 7 Jul 27, 2012 08:29 AM
Question SETUP Turnigy 9x with ER9X setup for NAZA? Medicineman76 Radios 0 Feb 26, 2012 08:51 PM
Question Turnigy 9x With Witespy w/Naza VC-450? Medicineman76 Multirotor Talk 2 Feb 19, 2012 03:54 PM