|
|
Thread OP
|
Help!
Graupner Propellor Stuck! Help
Test fitted my Graupner 10" on 2216 Tiger Motor, which came with a Graupner adapter to fit properly.
I have pushed the prop onto the shaft with adapter which was tight, and figured I need to trim down about 1-2mm of the adapter because it is taller than the prop. I now cannot remove the prop from the shaft! It was very hard to to get on, and seems impossible to remove. I have soaked in wd-40, with no avail. Advise please! |
|
|
|
|
||
|
Quote:
|
|
|
||
|
||
|
It rather seems to be a Czech substitute for Graupner adapter with apparently approximative dimensions.
http://www.electricwingman.com/graup...r/8mm/6mm.aspx : Quote:
|
|
|
Last edited by Mortimer; Jan 20, 2013 at 12:34 PM.
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | Maximum thrust possible propellor | gathem | Electric Power Systems | 28 | Feb 13, 2013 08:20 AM |
Discussion | really stuck please help flight Controller? | taffy047 | Multirotor Drone Electronics | 3 | Jan 07, 2013 12:16 PM |
Discussion | Champ controller stuck? | OhNoMrBill | Parkflyers | 1 | Jan 03, 2013 11:41 AM |
Discussion | Graupner Propellors suck (amps)! | Connexxion | Multirotor Drone Talk | 9 | Nov 09, 2011 12:05 PM |
Discussion | Graupner spinner stuck on | mumblety-peg | High Performance | 11 | Dec 23, 2009 11:28 PM |