Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Apr 06, 2012, 06:14 AM
TurboRacer is offline
Find More Posts by TurboRacer
Registered User
TurboRacer's Avatar
United States, CT, Waterbury
Joined Oct 2002
2,367 Posts
Help with Blade 400 / Futaba 9C setup please!

Has anyone done this? I have the RTF version of the Blade 400, and I have my Futaba 9C TX with Spektrum module.

I got it to bind, but I just can't figure out the settings to use to get the swashplate mixing correct. I got it working great on my MCPX, but I can't figure it out with this one..

I should note - I am using the stock RTF receiver in stock configuration. I don't have the stock TX for this bird. Maybe some of the servos plug spots need to be swapped? I have a fresh Spektrum RX I could use if I need to start over with a blank slate..

Any help would be greatly appreciated!!

TurboRacer is offline Find More Posts by TurboRacer
Last edited by TurboRacer; Apr 06, 2012 at 07:27 AM.
Reply With Quote
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! MCPX setup with a futaba 9c + DM8 module rhuber40 Micro Helis 10 Aug 13, 2013 04:47 AM
Sold Futaba 9c with 2.4 and trainer setup Nute Aircraft - General - Radio Equipment (FS/W) 4 Dec 16, 2011 04:00 AM
Help! Help...Futaba 9C Settings for a Blade mCX? 3D Romeo Coaxial Helicopters 0 Nov 01, 2011 01:12 AM
Help! Need help with futaba 9c V pitch setup Gun Jam 3D Flying 0 May 30, 2010 12:21 PM