|
|
|
|
Does anybody know how to program the speed controller that came with the kit? I plugged my ESC in and think the throttle servo channel is reversed. Went into some kind if program mode. I think when I moved the stick forward and back couple times I accidentally programmed it.
|
|
|
|
||
|
Quote:
|
|
|
||
|
|
|
Thanks for the post on the speed controller.
I'm going to go with Tim's idea and put the pilot tube in the wing. Does anyone know where to get more tubing? I didn't see any on RMRC. I think the inside diameter is 1.5 mm. I think you could get away with 2. I was thinking to use retract pneumatic tubing. I tried five Hobby shop so far and cannot find any plus I think it would be much more expensive than cheap silicone tube. |
|
|
|
||
|
Quote:
Best Steven |
|
|
Last edited by CN I Dawg; Oct 07, 2012 at 08:49 AM.
|
|
|
|
|
Steven,
Thanks. I will try that option as well. |
|
|
|
|||
|
Here's a video showing the gear I've used and how I have it setup on my Penguin for those looking for some setup direction:
|
||
|
|||
|
|
|
So to be clear, the horizontal and vertical stabilizers are held on with just the one machine screw? The only wood washers that I found were the motor shims. I used one of the thinner ones that I did not need for my motor type. I put lock-tite on the screw and tightened it down a fair amount until the wood washer was pushing into the foam a good amount. Does this sound like the way you guys built your kits?
|
|
|
|
||
|
Quote:
|
|
|
||
|
||
|
Quote:
|
|
|
||
|
|
|
Hmmm. I used a spare wood washer and put the 30mm screw through it then ran it up through toward the rudder, put lock-tite on it and tightened it down till the screw and wood washer sank a bit in the foam. Seems secure just odd that one screw holds the tail on. No glue?
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | fmkit's ULink (review/discussion/etc) | CrashMeUp | FPV Talk | 112 | Apr 07, 2013 05:34 PM |
Discussion | general engine discussion thread | cale10 | Engines | 273 | Nov 13, 2012 02:22 PM |
Spektrum DX7 technology discussion (moved from review thread) | Chipwillis | Radios | 62 | Jan 17, 2007 05:07 PM | |
Heliup.com CNC CF Shogun/Zoom frame build thread/review | Hoverup | Mini Helis | 123 | Jun 18, 2005 09:09 PM |