Speaking of Sims. What's a good Realflight plane for the 57?

Originally Posted by smithder

Speaking of Sims. What's a good Realflight plane for the 57?

this plane... https://www.rcgroups.com/forums/show...ostcount=16648


...and turn the sim physics speed up to 110%-120%

Thanks. I'll load it up now!

RealflightG5.5 Extra_AV
http://www.knifeedge.com/forums/down...=file&id=15658
and
The Color Scheme
http://www.knifeedge.com/forums/down...=file&id=15657

I'm biased as I spent over 6 hours making that color scheme.

Originally Posted by theKM

this plane... https://www.rcgroups.com/forums/show...ostcount=16648


...and turn the sim physics speed up to 110%-120%

Could not load up for some reason...

I have the other Extras... thanks.

Check out this 71" Slick. I know it is not an Extra, but its a great flyer!

http://www.knifeedge.com/forums/down...=file&id=15137

Originally Posted by gabrielisrael

Could not load up for some reason...

I have the other Extras... thanks.

Check out this 71" Slick. I know it is not an Extra, but its a great flyer!

http://www.knifeedge.com/forums/down...=file&id=15137

what version of realFlight?... did you unzip the file first?

Originally Posted by theKM

what version of realFlight?... did you unzip the file first?

got it... unzipped and loaded.

is there any scheme variants?

Does anyone know the settings for a castle ice controller with a Hacker A40-12s?
Thanks.

Originally Posted by jpinn

Does anyone know the settings for a castle ice controller with a Hacker A40-12s?
Thanks.

This is what I have on mine with the motrofly 3620 and it works great. Got the settings from a post from losi. Running a ice 100.


Vehicle type: Airplane
Throttle type: Fixed endpoints
Throttle responce: High (8)
Brakeisabled
Cutoff Voltage: 4 volts
Current limiting: Normal (150amps)
Cutoff type: Soft
Motor start power: Medium (59)
Motor timing: Low (0)
Direction: Forward
PWM rate: 8KHZ
BEC voltage: 6 volts
Logging: Disabled

Current Limiting - disabled

logging off

those are for sure

timing, response, etc. I leave at factory defaults unless something comes up

and hacker told me the PWM is actually 12 and you cant set the esc to 12 so he said leave it on "outrunner" so it will automatically adjust itself

Originally Posted by gabrielisrael

got it... unzipped and loaded.

is there any scheme variants?

a dude made an SHP scheme for it... it's in the 47 SHP thread someplace... will need to do a search for it...

On the pull-pull, when the rudder cables slacken after the first few flights, is it usually enough to just back off the set script and move the coupler in deeper? Or will I have to uncrimp and reloop the entire setup. Thanks

Originally Posted by chriscap

On the pull-pull, when the rudder cables slacken after the first few flights, is it usually enough to just back off the set script and move the coupler in deeper? Or will I have to uncrimp and reloop the entire setup. Thanks

dont uncrimp and reloop unless you absolutely have to....take the slack out of the linkage like you said

is it usually enough to just back off the set script and move the coupler in deeper