percentage power steps to run led setup
With the DX6i tx and 6200 rx how do I produce steps in the power to an led light circuit, just a plug and play set up to plug into 1 servo plug-
The light set comes from - Tiny Bright Lights
20% turns some on (nav) 30% more (anti collision), 40% more (landing) and 60% all are on with (spot).
The manual isnt helping on this.
I did, no reply yet. I guess I should know more than I do about setting the transmitter up, Am trying again in the am but spent 2 days going through the manual and trying to figure it out.
I guess I am supposed to be able to make the flaps switch step through perentages but cannot get it yet.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Night Fly LED Setup for Foamies||the_canuck||Foamies (Kits)||1||Mar 07, 2006 02:28 AM|
|Need Power Supply to run 2 chargers||nxtdoor||Batteries and Chargers||2||Apr 26, 2005 02:15 PM|
|I want to make a computer power supply to run my field charger??||robertjusher||DIY Electronics||3||Apr 17, 2005 09:58 PM|
|Poppy with it's new LED setup||dawnron1||Parkflyers||11||Apr 23, 2004 04:02 PM|
|Question about Imeins tail LED setup||robw||Micro Helis||6||Apr 07, 2003 11:05 AM|