Scratch builder paint tips / ideas: instructional videos - Page 136 - RC Groups
Thread Tools
This thread is privately moderated by adreher, who may elect to delete unwanted replies.
Apr 02, 2018, 08:18 AM
Go fast, turn left....
BlindFury's Avatar
Quote:
Originally Posted by Sixter
I 've used Krylon H2O Spray Paint successful on EPP for years. I have depleted my supply of Krylon H2O paint. Now, I found that it is no longer available! Which Spray Can Paints are you guys using on EPP? The thing I liked about the Krylon H2O was all I did was mask off an area and spray it! Suggestions will be appreciated

Bobby
Krylon Short Cuts work very well on EPP.
Sign up now
to remove ads between posts
Apr 02, 2018, 09:03 AM
Registered User
I've been painting doculam and have finally bought a airbrush which I'm enjoying, I paint the inside of the covering so there's no final coat, my newest is a ghost flame job on my stinger 120, the airbrush is the way to go, paint is cheap and goes a long way, stencils are easy to make and use
Apr 06, 2018, 08:51 PM
A Day @ a Time - Matt. 6:25-34
ruff1's Avatar

Paint Recommendation?


I have decided on coffee filters and 60/40 Titebond II - water with a Polycrylic covering to go over balsa and FFF. It provides a reasonably hard shell and sands smooth.

I did some trial and error with ideas in Hoppy's newspaper glue covering thread:
https://www.rcgroups.com/forums/show...ng-improvement

I'm looking for a recommendation for painting over this. I'm not equipped with a spray gun / compressor, so looking more for a rattle can solution. I believe the covering can take paints that would eat foam. I don't think brushing on something would look good. I figure several light coats would work the best.

Color scheme will be primarily white and silver with some navy and gold trim.

Clear coat is something I'll consider but not an absolute requirement.

Thanks.
Apr 07, 2018, 07:50 AM
Registered User
a harbor freight airbrush is like 10 dollars, and easy to use, the paints are a dollar and the go a long way, not to mention all the colors you could want. If you have to go spray can, I would prime it sand the primer mostly off, and then buy one brand of paint for the colors, and hope for the best, krylon would be the easiest to use, my problems never occurred with the base coat, it was when I did the trim color, it never came out right, the airbrush solved all of my problems, well enough to try a flame job.


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Scratch builder's miniture miter at harbour freight splatman Scale Kit/Scratch Built 1 Dec 01, 2016 07:29 AM
Tips for Taking Videos? kelvin Electric Plane Talk 48 Apr 18, 2003 01:55 PM
Gimme some paint scheme ideas for the Pico Jet Pierre Audette Foamies (Kits) 7 May 23, 2002 08:32 AM
New Zagi 400x builder, any tips for me? slowflyer Foamies (Kits) 16 May 09, 2001 04:28 PM