Thread Tools
Jan 06, 2009, 04:06 AM
Registered User
jacky65's Avatar

BlackStork OSD - Current sensor pinout

My heli eats more than the 50 Amps of Current sensor capabilities, so I can not use it as is but I would like to probe the motor battery voltage.
Is it possible use the BlackStork OSD's current sensor pins for only motor battery voltage monitor?
There are 3 pins for the sensor: GND, +12V and A.
What signal is pin "A" ?
and the +12V is an input or output voltage from OSD ?
Thanks in advance for your feedbacks
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Vizion OSD with current sensor ($50 shipped) + video switch VasMan Aircraft - General - Miscellaneous (FS/W) 1 Dec 21, 2008 04:21 PM
Discussion Black Stork OSD Current Sensor Calibration Question:) danje FPV Talk 6 Oct 31, 2008 12:25 PM
Sold Vizion OSD (V3) with Current Sensor - $80.00 SHIPPED VasMan Aircraft - General - Miscellaneous (FS/W) 1 Jun 13, 2008 01:39 AM
Help! Current sensor rc-pilot-freak DIY Electronics 17 Jan 18, 2007 05:04 PM
Discussion Current sensor/limiter dusty IV DIY Electronics 3 Aug 07, 2006 03:13 PM