|
|
|
Thread OP
|
Discussion
Black Stork OSD/ For Sale
I am not sure if I can post this here but I figured it would just get lost in the "For Sale" section.
I have a very slightly used Black Stork OSD for sale. $150 shipped (OBO) The OSD comes ready to fly with everything you need . There is an LS20033 GPS with connecting cable, a 50A current sensor, and even several male to male servo connectors to help you connect this to your RC receiver. It has been upgraded to ver 1.4 and I will throw in the USB upgrade key ($40.00 value) I must tell you that I did burn a trace on the board and rather than sending it back the manufacturer (avionicsrc) told me to solider a piece of wire where the trace was. It works perfect. The original heat shrink was cut off to replace the trace. I put on new heat shrink and wrote the pin configeration on it. The photos I have attached are not of the actual unit. I can post them tonight. Reason for selling: I am going to stick with AP for now. FPV scares the hell out of me  I have $250.00 invested in the unit. Features: Speed measurement Flight pack voltage measurement through a 50A current sensor Video battery voltage measurement Motor current consumption TV System: menu selectable PAL or NTSC Battery usage and power guage (motor) Distance to home Dynamic Directional Arrow Altitude Fight time |
|
|
Last edited by IFLYRCAZ; Nov 11, 2008 at 12:24 PM.
|
|
|
|
|
|
|
|
ill take it post a pic of the unit.
|
|
|
|
|
|
|
|
|
danm G-unit i need this RV has not mailed my rvosd
|
|
|
|
|
|
|
|
|
right on!
|
|
|
|
|
|
|
|
Thread OP
|
I had somebody ask me about the issues I was having when I did the firmware upgrade to the unit. When I upgraded the firmware one of the screens was missing. I sent an email to hobby wireless and got a reply that stated that in the new firmware one screen was left out because avionicsrc thought that it was as redundant screen. I have the original email that I can foward to anybody who needs to see it if its holding them up from making a decision on the purchase.
Thomas |
|
|
|
|
|
|
|
Thread OP
|
Photos as prmised. I will put new heat shrink on the current sensor and OSD before they hit the mail that war they are clean looking and dont have velcro glue on them.
|
|
|
|
|
|
|
|
|
hehe i thought its was sold? pm me your pp addy
|
|
|
|
|
|
|
|
|
hay send the heat shrink ill replace it, i will check the board out anyway
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion | Intelligent flight OSD for sale on Ebay | VRflyer | FPV Talk | 5 | May 01, 2008 04:08 PM |
| For Sale | T-Rex 600E Black CF Frames For Sale | dfrazier | Aircraft - Electric - Helis (FS/W) | 1 | Aug 17, 2007 05:52 AM |
| I have a Black Widow system for sale! | airmcn_3 | Aerial Photography | 5 | Jun 07, 2005 06:48 AM | |