The 6x carbon fibre rods were tacked to the plastic with a small amount of thin CA, then GWS glue was used to hold them into the fuselage. This method was clean and quick and provided a good bond between the carbon fibre rods and the foam.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||GWS F15 build thread!||Extreme_RC||Australia||80||May 30, 2010 09:24 PM|
|Discussion||Gws F15 即將上市!||GWS4CEO||Taiwan||22||Aug 05, 2007 10:18 AM|
|Discussion||Gws-f15量產版飛行測試||gws-tommy||Taiwan||0||May 13, 2007 11:53 PM|
|Discussion||GWS F15 is comming.||GWS4CEO||Parkflyers||6||Apr 02, 2007 08:43 PM|