Thread Tools
Oct 16, 2008, 11:13 PM
Registered User

What Engine For Aero-Works Yak 54 .60 - .90

I am going to buy an Aero-Works Yak 54 .60 to .90

What engine would you guys recommend. I want to install a gas engine not glow. Any feedback would be appreciated.
Sign up now
to remove ads between posts
Oct 16, 2008, 11:33 PM
Got toys?
kenhiraihnl's Avatar
you should visit the aw90-120 thread on the other'll take you a coupla hours to read through it, but you'll get a better idea what engines (gas, glow, 4-cycle) work in that's a post from that thread...ken

This plane is awesome. It can accept a wide range of engines and all seem to power it well. Here are your options:

O.S. 1.20 AX (Good power, can hover, o.k. pull-out)

O.S. 1.60 FX (Great power, can hover, good pull-out)

Saito 1.25 (Adequate power, can hover, o.k. pull-out)

Saito 1.50 (Lots of power, can hover, great pull-out)

Saito 1.80 (Lots of power, can hover well below half throttle, great pull-out) I have this set-up.

Y.S. 1.40 (Lots of power, can hover, great pull-out)

Evolution 26 (Good power, can hover, ok pull-out)

SPE 26 (Lots of power, can hover, great pull-out)

I'm sure there are more engines out there, but these seem to be the ones that people have actually used and have liked the set-ups. Basically, if you want lots of power, either go with the Y.S. 1.40, Saito 1.50, O.S 1.60, Saito 1.80, and SPE 26cc. These engines will give you lots of power. If you go gas, you will need a extra battery and you will use an ignition module, but according to Jimeni, you will have lots of power. For the Evolution, read the article below by Quique and decide.

Hope this helps in your decision. Whatever you go with, you will have lots of fun with this plane. It's that nice!
Last edited by kenhiraihnl; Oct 19, 2008 at 06:29 PM.
Jun 04, 2010, 08:27 AM
Registered User
I have an OS 91 Surpass II, and a Magnum 1.20 4-stroke. Which of these should I use? Is the OS 91 enough engine?
Aug 08, 2014, 01:00 PM
Registered User
Hello i just obtained an aeroworks 60 yak 54 with a saito 180. Can anyone recommend a good set up?
Receiver? Thinking if a powersafe set up. Spektrumrum
Servos i need 5. Im thinking of the hitech 5625
Battery for rx ?
Dk you have redundancy?

Would be greatly appreciated
Aug 08, 2014, 02:05 PM
RC Addict
rmsingh's Avatar
Sorry wrong thread

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Qui Que Yak vs Aero Works Yak 54 Txtoby Competition Aerobatics 1 Sep 05, 2008 08:34 PM
Sold NIB: Aero-Works Yak 54 .90-1.20 QB Arf Yardbee Aircraft - Fuel - Airplanes (FS/W) 0 Nov 21, 2007 02:22 PM
Sold Barely Flown Aero-Works Yak 54 QB 50cc $475.00 ~SnApRoLl Aircraft - Fuel - Airplanes (FS/W) 0 Jul 15, 2007 10:19 AM
What sould I get for 28" Yak 54? bamm 3D Flying 0 Mar 31, 2005 09:46 PM