Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Feb 17, 2003, 03:44 PM
BryanHarstad is offline
Find More Posts by BryanHarstad
Registered User

Whats the best way to connect pushrod to servo arm?


I have a Hornet with CP, I am having a real hard time inserting the small brass pin to connect the pushrod to the servo arm. So far, while trying to connect them, I have lost two pins, and broken one push rod.

Whats the secert to getting the brass pin in?
I was thinking of drilling the holes out, and gluing the pin in.

What did you do?

Bryan Harstad
Somewhere in ND
Sign up now
to remove ads between posts
Old Feb 18, 2003, 12:10 PM
tauscnc is offline
Find More Posts by tauscnc
Registered User
tauscnc's Avatar
hey Bryan,
Yes getting those pins in can be tough. The hole in the servo control arm is to small for the pins. Find a tiny drill bit, screwdriver, allen wrench etc to "drill out that hole." The trick is to get the pin in so it can move freely without much play.

tauseef
www.cuttingedgecnc.com


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Want To Shorten My Servo Wires, Whats The Best Way?!? Minimole Electric Plane Talk 7 Apr 13, 2006 11:43 PM
Whats the best way to use a Servo to trigger Mini 3 RandyK1 Aerial Photography 2 Nov 21, 2003 06:43 AM
Whats the best way of forming foam? Aubrey Foamies (Kits) 0 Feb 28, 2002 01:19 AM
down thrust, right thrust, Whats the best way to do this? hawkeye_abm Beginner Training Area (Aircraft-Electric) 5 Feb 08, 2002 09:23 AM
aggg, whats the best way to connect 2 computers?? TheSpruceMoose Life, The Universe, and Politics 23 Aug 01, 2001 01:06 AM