|
||
|
Quote:
Thanks http://www.bleedingedgeracing.com/product_p/k.mz212.htm |
|
|
||
|
|
|
|
Hi, i use this
http://www.rceasy.com/wp-content/upl.../02/k82002.jpg but chose this to have a precise motorcycle, but also putting the receiver on 27MHz is possible to make a good bike. if you choise buy the first link, not the receiver for mr02, is expensive and is the same for the mini z car |
|
|
|
||
|
Quote:
|
|
|
||
|
|
|
if you buy this http://www.bleedingedgeracing.com/product_p/ic-004.htm
you need only couple of crystal for your 27 mhz radio is receiver and esc combined, two in one |
|
|
|
||
|
Quote:
|
|
|
||
|
|
|
|
|
|
|
|
|
PM sent
|
|
|
|
|
|
I emailed Silverlit about extra batteries for the bike. Found out how much they were and so sent them my postal address, they said once they'd receive payment they would post out some batteries to me.
My wife just sent me an email saying "a package has shown up, its just bubble wrap no invoice and there is what looks like batteries with wires sticking out of them, do you know what they are?" Took me like 10min to realise that they had posted out the batteries to me....and hadn't sent them any money/finalised the order. I now have 4 stock batteries for my bike (since I bought a 2nd bike) |
|
|
|
|
|
Dont know if anyone can help me before I go mad but I have bought a mini z board for my Silverlit bike, taken off the motor that was on it, ( I take it that was the servo motor?) I then unsoldered the pot, I then found a servo took out all the electronics and just left the pot and the motor, wired up the pot and motor in the new servo but the motor just runs and tries to spin the output shaft round and jams up I dont really know enough about how the servo should work, I thought it was strange how the servo should work with out any electronics in it but what do I know maybe I need a special servo? can anybody help before I give up and go back to how it was with the old radio but spent hours getting nowhere First pic is the servo I wired up second is the board how I bought it.
Thanks |
|
|
|
|
|
Thanks, but I have cut the Kyosho Parts off and soldered the wires straight to the pot and servo motor
Thanks |
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
1/3 scale Tyco r/c motorcycle! | Kmot | Motorcycles | 158 | Dec 05, 2005 08:31 PM | |
Am I the Only 1/8th R/C Driver? | NitroEvolution | Large Scale Cars | 17 | Mar 17, 2005 06:33 AM | |
Cheap 25mph R/C motorcycle Setup! | sithos | Cars - Cars and Parts (FS/W) | 2 | Dec 04, 2003 08:19 AM | |
Installing brushless on normal 1:10 R/C car. Any experience? | Risto | Electric Power Cars | 3 | Mar 20, 2002 12:45 PM | |
Sceince for kids, sub 1 oz R/C planes | aeronutz | Scratchbuilt Indoor and Micro Models | 3 | Dec 17, 2001 05:23 PM |