Dimensions of robart retracts? - RC Groups
Thread Tools
Feb 01, 2003, 10:10 AM
SVX
SVX
Registered User
SVX's Avatar

Need smallest retracts to support 25oz?


I would like to find a small (shallow) retract to fit in a plane that should come in at 20-25 oz. The dimensions that surfer was kind enough to give me of the Robarts were a little too deep. Any ideas?
Thanks, Dustin
Last edited by SVX; Feb 03, 2003 at 12:42 AM.
Sign up now
to remove ads between posts
Feb 02, 2003, 04:20 AM
Registered User

dimensions


these are the dimensions:

-Block dimensions:

1 5/8 (41.3mm) lenght
29/32 (22.9mm) Wide (outside)
9/16 (13.7mm) wide (inside)
23/32 (18.2mm) max deep

-the 3/32 wire strut is really long and you cut it on dimension.

Hope it helps,

difficult to explain without the map but I can't scan it.
Feb 02, 2003, 08:32 PM
SVX
SVX
Registered User
SVX's Avatar
Thank you much, that's just what I needed.

Dustin


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Robart 615 100 degree rotating retracts with 3 1/4 robart wheels sagomon Aircraft - General - Miscellaneous (FS/W) 4 May 03, 2014 07:45 AM
Sold Robart 615 100 degree rotating retracts with 3 1/4 robart wheels $100 sagomon Aircraft - Fuel - Airplanes (FS/W) 0 Apr 15, 2014 05:17 PM
For Sale Robart retracts /with Robart wheels fh64_lucky Aircraft - Fuel - Airplanes (FS/W) 3 Oct 07, 2012 01:09 AM
Sold Robart Scale Retractable Tail Wheel and Robart cylinder indycobra Aircraft - General - Miscellaneous (FS/W) 3 Apr 22, 2011 01:57 PM
For Sale 1/6 Scale Robart AT-6 Retracts Robart#620 fockewulf37 Aircraft - Fuel - Airplanes (FS/W) 0 Dec 16, 2005 08:24 PM