4#3 2.4ghz conversion possible??
Hi everyone,I would like to know what all is needed to convert my 4#3 into 2.4 ghz,I already have the 4#3b so I know I can use the tx.My reason for this is I'm having all kinds of problems w/my reg. 4#3's rx/tx it's not flyable and I was about to give up on it but I have so many spare parts for it,it would be a waste for it to just sit and collect dust.Is it possible to by a 2.4 ghz rx and start flying it again or is there more to it??? any help on this would be GREATLY APPREACITED.
Thanks in advance guys.......
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||Yet another Evo9 2.4GHz conversion||mmormota||DIY Electronics||24||Feb 05, 2009 08:34 AM|
|Discussion||my 4#3 2.4ghz TX decided to start talking||axelen||Micro Helis||9||Jun 12, 2008 02:46 PM|
|Discussion||Walkera 4#3 2.4ghz metal version||Patrick R||Micro Helis||8||Jun 01, 2008 10:24 PM|
|3 Cutting Bows 4' 3' 2' and a roll of wire||Gunny||Aircraft - Sailplanes (FS/W)||0||May 01, 2004 04:58 PM|
|3 Cutting Bows 4' 3' 2'||Gunny||Aircraft - Sailplanes (FS/W)||0||Apr 21, 2004 12:28 AM|