Thread Tools
Aug 01, 2001, 06:48 PM
Looking for a place to crash
Had the same trouble when i didnt make the groove deep enough. I epoxied mine in and made several trial fits before the final glueing.

If you can get it out redo it or if not don't worry, it wont effect the flight.

Sign up now
to remove ads between posts
Aug 02, 2001, 12:56 AM
Registered User

Biulding my new Zagi

I have a question about glueing the spars onto the Zagi. I glued them in last night and the short middle one is bulging out a little towards the wing root section. Should I have carved out the grooves to have it be more flush? I had this same problem with one of the long spars too. I tried putting some weights on top of them to hold them down overnight, but it did not work. Maybe something heaver?

I realize it probably won't affect flying too much, but was just curious if others have experienced this problem. I also learned that I should use gloves when using that darn sticky 3M 77 glue. I read a post earlier in the month saying that you don't need to use too much glue. That is sure not what the Zagi directions say, they want you to use the entire can !


[This message has been edited by markpsmith (edited 08-01-2001).]

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
my new zagi fix is cracked btrod Parkflyers 7 May 26, 2003 02:55 PM
My new Zagi! Zagi-Extreme Foamies (Kits) 10 Mar 10, 2003 11:26 PM
My New Zagi Steven DiStasio Foamies (Kits) 4 Aug 26, 2002 03:38 PM
My new Zagi blew up! ErnieR Foamies (Kits) 8 Jun 12, 2002 09:08 AM
My New Zagi 400-X AirVenture Foamies (Kits) 17 Aug 07, 2001 12:01 AM