Thread Tools
Old May 26, 2008, 06:09 PM
blakevan is offline
Find More Posts by blakevan
Ta-dah!
blakevan's Avatar
Question

AR6200 Blinking Lights


What do blinking lights on an AR6200 mean? I have been using AR6100s mostly but switched to the AR6200 and seem to get solid lights some times and blinking lights others. Both times all servos work but I don't trust this and cannot find any mention of this situation in the binding instructions.

Thanks for the help.
Sign up now
to remove ads between posts
Old May 26, 2008, 06:25 PM
Gregg28 is offline
Find More Posts by Gregg28
Don't lie to my dog.
Gregg28's Avatar
From what I understand, the blinking lights mean that the receiver had lost signal or power at some point since it was powered up. This can happen if you turn the plane on before the transmitter.
Old May 26, 2008, 06:56 PM
Pinecone is offline
Find More Posts by Pinecone
Will fly for food
If it is a new Rx, it is low voltage indication.

It can happen when you plug in the pack if you bounce the connection.

It will work fine.

You can get the lights to go solid by power cycling the Tx.
Old May 26, 2008, 09:06 PM
blakevan is offline
Find More Posts by blakevan
Ta-dah!
blakevan's Avatar
Great, thanks for the help guys.
Old Sep 08, 2008, 05:45 PM
sajeev is offline
Find More Posts by sajeev
Registered User
in my case it was a bad BEC on my ESC...
Old Sep 08, 2008, 06:09 PM
blakevan is offline
Find More Posts by blakevan
Ta-dah!
blakevan's Avatar
Sorry this was on a fuel plane so it was plugged directly into the RX pack.


Thread Tools