T-28 Flap Job
These are a few pics of the flaps that I have installed on my T-28 Trojan. I did my best to make it look like the plane came with the flaps on them... and all I used was a super sharp knife, ruler, sand paper, and hinge tape.
I did not include any pics on the "making process" but if you scroll up to my blog entry on "making ailerons" you will see the same process (but how it was done on my Super Cub)
1st switch position = 0in
2nd switch position = 0.5in
3rd switch postion = 1in
I also included pics of the settings in my dx-7 for the flaps on this plane.
Last edited by ty_horn; Nov 20, 2008 at 03:44 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|T-28 Trojan Build||Ralph A. D'Amelio||Scale Kit/Scratch Built||58||Apr 12, 2008 12:40 AM|
|45"ws T-28||Ralph A. D'Amelio||Scale Kit/Scratch Built||24||Jun 04, 2006 08:45 PM|
|FS: NIB Pica t-28 1/5 scale + extras||fbret||Aircraft - Fuel - Airplanes (FS/W)||1||Nov 13, 2003 03:24 PM|
|wal-mart foamboard T-28||BIFFSTER||Foamies (Kits)||4||Oct 09, 2003 08:23 PM|
|T-28 Trojan||Ralph A. D'Amelio||Scale Kit/Scratch Built||12||Aug 09, 2003 07:30 PM|