Got the Body Done - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by Vethraxx, who may elect to delete unwanted replies.
Feb 06, 2008, 09:32 PM
Registered User
Vethraxx's Avatar

Got the Body Done

I got the fuselage completed according to the directions. There was a minor work around as I did not know what canopy formers 9a and 10a are suppose to attach to. They seem to be floating in mid are. I just improvised a little. The longs is a bit warped when you look at it top down. I will try and correct it with water and a hair dryer. Not wanting to cut it up to correct a little warping. Solid piece of balsa for the tail, front end is open. Now I can start to figure out where to cut and remodel some of it to make the top accessible for the batteries, motor etc. Should be fun. Next.. the wings (squeal of excitement). (Never built a non die/laser cut model before)
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Got Er Done!!!!!! racingodds Slope 20 Oct 28, 2006 07:55 PM