What size servos for a fixed pitch .30(?) size heli?
I a complete newcomer in regards to helicopters. I have however been flying RC airplanes for 10 years and am currently a flight instructor for two local clubs. I design and build my own planes as well.
I just picked up a used but not abused Revolution fixed pitch helicopter with all the parts except the canopy. It has a rotor diameter of 42" so I'm guessing it's a .30 size from looking at stats on other helis rotor diameters. I've done numerous searches and can find a few parts available from Horizon but not the Revolution website. I'd love to find a copy of the original instructions if that is at all possible.
A few questions.
1. What size servos should I use? I have a Futaba radio and Hitec RX.
2. Where should I balance or place the CG on it?
3. Is there a website that I missed?
4. What sort of angle should I make the cyclic(?) tilt to at full servo travel?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||OS .37 SZH Heli Engine for R/C 30 Size helicopter - Starting bid at $20.00!!!!!!!!!!!||jodini||Aircraft - Fuel - Helis (FS/W)||5||Oct 15, 2006 03:17 PM|
|Jazz 40-6-18 Mode for Fixed Pitch Heli (Corona)||yellow||Kontronik||4||Dec 04, 2004 01:56 PM|
|What rudder servos for Shuttle 30||goldenpower1||Fuel Heli Talk||1||Jun 12, 2004 07:04 AM|
|What rudder servos for Shuttle 30||goldenpower1||Electric Heli Talk||1||Jun 11, 2004 09:16 PM|
|Governor mode ESC for a fixed pitch heli?||HankF||Electric Heli Talk||1||Jun 27, 2001 03:38 PM|