I am selling the stock Esky 4 in 1 and stock Esky (2) servos from my HBFP. I ran two batteries through my FP and experienced major glitches while flying it in my basement. One glitch even caused the heli to take off across the basement without me even touching the controls....It crashed with zero visible damage.

Anyways, I have had great luck with my DX6/AR6000 in all of my planes. I purchased a 3 in 1 controller and installed my AR6000 RX in the FP. While I was at it I installed two HS-55 servos which I have more confidence in. I am not selling the stock HBFP TX because I can connect that to a computer with the included Esky cable.

I wanted to be as honest as possible regarding all details. As far as I know, both servos and the 4 in 1 should work okay, assuming the glitches I experienced were caused by either a bad TX or FM interference. The FM frequency for the unit is 72.830.

These three parts retail new for about $55 to $60 plus shipping. I will sell them with no guarantees, and include shipping in the US for $33 total.

If you can put it to good use then make an offer. I just want to offset some of my cost in the 3 in 1 I purchased ($42), and make it worth the trip to the post office to ship out.

Thanks Guys!

Some pics would be nice. How much time on it?

Spaman,

I'll try to get you some pictures....it's the same stock 4 in 1 and 8 gram servos found in all the parts lists for the HBFP.

The total time has to be under 30-45 minutes. I was able to complete a couple of RADD's "hold the tail" lessons on the ground and then I started getting all of the glitches I mentioned above....switched over immediately to DX6 & HS-55's.

Here you go Spaman.

I'll give you $25 Shipped

Spaman,

Check your private messages.

Payment sent.