Will APC Folding props fit directly on a SP400? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
May 27, 2001, 03:04 PM
Registered User
Foxtrot's Avatar

Will APC Folding props fit directly on a SP400?


Without any adapters that is.
Sign up now
to remove ads between posts
May 28, 2001, 06:21 AM
RIP Azarr - "Old age is not for sissies"
Azarr's Avatar
Unfortunately no, you need an adaptor.

Azarr
www.azarr.com

Quote:
Originally posted by Foxtrot:
Without any adapters that is.
May 29, 2001, 02:42 PM
Registered User
Foxtrot's Avatar
Should've asked this too. What adapter do I need. What shaft do these props fit. Thanks.
May 30, 2001, 05:16 AM
RIP Azarr - "Old age is not for sissies"
Azarr's Avatar
For some unknown reason, APC decided to use an 8mm shaft hole. There are several adaptors available from HL that fit this need.

Azarr
www.azarr.com

Quote:
Originally posted by Foxtrot:
Should've asked this too. What adapter do I need. What shaft do these props fit. Thanks.
May 30, 2001, 07:33 PM
Registered User
APC should supply the motor shaft adapters/collets/nuts to fit the 8mm hole in the middle part yoke for their new folding props, also spinners to go along with them.
One should not have to deal with H/L any more than they have to!
May 30, 2001, 10:32 PM
Registered User
REFER
Whats the problem with H/L?? I have always been pleased with the service from them. Might wish for lower prices, but thats always true.

Did you have a bad experience that we should be warned about?

Regards, Dave