Hanger 9 Sopwith Camel
Hello folks, I'm posting this for a very good friend as he does not have access to the internet. This plane is complete with engine, RX, servos, all the hardware and all ready to go, just add your RX crystal and go fly.
Item: Hanger 9 Sopwith Camel - absolutely complete and put together - never flown.
Engine: New Saito 100 with stock muffler
Servos: 5 x Futaba 3001 series servos
RX: Futaba 8 channel FM RX
I think all new, this would go for a whole lot more, not to mention trips to the hobby store, shipping, etc.
1. I believe that the servos and RX are new.
2. There is a remote glow adapter (can be seen on the last pic).
3. There is a fueler (can be seen on the 3rd and last pic).
4. All hardware is new.
5. Meticulous UltraCote trim scheme and other scale features, such as an engine, guns and pilot figure all included.
$ 469 for the package shipped.
Last edited by coloradoz; Sep 21, 2007 at 11:58 PM.
Ok, I'm told that its about between 10-15 minutes, depending on proficiency. The wings both bolt on first. The guy wires are already attached on one wing and snap onto its correct position on the upper/lower wing (your choice). The way this is setup, you won't have to connect both ends of the guy wires - just the open end to the right position.
Last edited by coloradoz; Sep 22, 2007 at 11:51 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||Hanger 9 Sopwith Camel||fudi50||Aircraft - Electric - Airplanes (FS/W)||0||Dec 19, 2006 12:51 PM|
|Discussion||hanger 9 Sopwith Camel||fudi50||Power Systems||5||Oct 02, 2006 04:14 PM|
|Discussion||Hangar 9 Sopwith Camel !!!||tailskid2||Fuel Warbirds||32||Sep 30, 2006 01:51 PM|
|Discussion||hanger 9 Sopwith Camel||fudi50||Electric Motor Design and Construction||1||Sep 15, 2006 09:02 PM|
|Build Log||New AerodromeRC 1/9 Sopwith Camel||sleonard||Scale Kit/Scratch Built||15||Sep 14, 2006 05:22 PM|