Thread Tools
Old Sep 18, 2007, 10:23 AM
Boss248 is offline
Find More Posts by Boss248
ProBro # 501
Boss248's Avatar
Discussion

I am looking for a JR 9303 guru


I am totally confused...I have a Gold berg bipe thst I am finally finishing. My problem is I am running 2 servos one for each but Can't get my tx to gang them together and still have trim on 1 elevator. Is the any one out there that can help. I am not a newbie just a dummy..

Boss
Sign up now
to remove ads between posts
Old Sep 18, 2007, 11:01 AM
staggerwing is offline
Find More Posts by staggerwing
In NY's beautifull hills
staggerwing's Avatar
Boss,
You're in the wrong forum---this is giant scale elec planes
Old Sep 18, 2007, 11:44 AM
Boss248 is offline
Find More Posts by Boss248
ProBro # 501
Boss248's Avatar
Quote:
Originally Posted by staggerwing
Boss,
You're in the wrong forum---this is giant scale elec planes
I thought someone might have run into this problem..what forum should I be in..>>>

Boss
Old Sep 18, 2007, 12:09 PM
spyderron is offline
Find More Posts by spyderron
RC Maniac
spyderron's Avatar
This should get you going in the right direction.
http://www.rcuniverse.com/forum/m_57...tm.htm#5754053

If not, go to the JR site and look through the different setups they have. They explain it well. Personally, I have a matchbox on my 50cc so I don't have to adjust the rt and lt elevator endpoints manually.

Ron
Old Sep 19, 2007, 09:11 AM
Fool is offline
Find More Posts by Fool
Jim H
Go into 'DEVIC SEL' set AUX2 to INH
Then go to 'WING TYPE' set ELEV mate to AUX2.
Plug the right elevator servo into elev and the left elevator servo into aux2
Use servo rev as required.


Jim
Old Sep 19, 2007, 12:59 PM
Boss248 is offline
Find More Posts by Boss248
ProBro # 501
Boss248's Avatar
Quote:
Originally Posted by Fool
Go into 'DEVIC SEL' set AUX2 to INH
Then go to 'WING TYPE' set ELEV mate to AUX2.
Plug the right elevator servo into elev and the left elevator servo into aux2
Use servo rev as required.


Jim
Thanks Jim..that did the trick..I bet I wasted 3hr. on this damned JR 9303..it;s might be futaba..who knows for sure..it might be 2.4 for all of us..

Happy Boss..I thought I was going to have to use one of the servo reverser which I have had bad reports on them.so I am delighted to say the least.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Looking For Jr Micro Reciever-jr610m SKYWARN Aircraft - Electric - Airplanes (FS/W) 3 Jan 04, 2003 06:08 PM
Cool I am looking for a RTF or ARTF that is under $200 Wingo1121 Aircraft - Fuel - Airplanes (FS/W) 12 Oct 25, 2002 12:10 AM
I am looking for a jet rcman Electric Ducted Fan Jet Talk 1 Sep 06, 2002 11:52 AM
Looking for a JR fm receiver, at least 4 channel deadcell Aircraft - Electric - Airplanes (FS/W) 2 Oct 11, 2001 07:32 PM