Fleet (6): Multiplex Easyglider
This is my 1st Multiplex plane, and it is a very simple build (except the battery compartment needed extending for my 3S LiPos, the rear balance ball bearing was a mistake, and the aileron covers were too proud of the wing underside).
The plane is pretty much stock (ie stock GB and 400 motor). I used a separate BEC as this plane uses 4 servos. One very nice touch is that the original box can be used for storage (with the tail sticking out the end).
Flying requires a somewhat different style vs other aileron planes, with a requirement to use rudder for good turns. The maiden was wrong because I did not pay too much attention to CoG (and no it won't fly with the stock ball bearing and LiPos way back in the battery comparment). More fool me. De-balled and balanced, it went very nicely on the 2nd maiden, except maybe it was a tad too windy for comfortable flight. But at least that meant a 2 feet landing run!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Multiplex EasyGlider Thread 2 - A New Saga Begins||Bad Attitude||Foamies (Kits)||2526||Aug 14, 2006 09:03 AM|
|Cool||Video's GWS PT-17 & Multiplex EasyGlider||JustGoFly||Foamies (Kits)||0||Jan 13, 2006 10:41 PM|
|Discussion||Multiplex EasyGlider - Started build - how's it look ?||JustGoFly||Foamies (Kits)||0||Dec 28, 2005 07:35 PM|
|Multiplex EasyGlider for AP?||sweatyfingers||Aerial Photography||2||Jun 01, 2005 03:46 PM|
|New from Multiplex: EasyGlider||Jurgen Heilig||Foamies (Kits)||524||May 23, 2005 07:30 PM|