22" F117 Foamie - RC Groups
Thread Tools
Aug 04, 2007, 03:17 PM
Registered User

22" F117 Foamie

Been working on a 22" span F117 foamie. Original plane flew straight & level just awsome... Had to cut the fuselage profile down quite a bit so that it will turn without having to point its nose at the ground and roll it and then pull up.

Motor is a based on a GoBrushless GBv kit with a castiron flux ring, Aluminum end bell, bearing block made from 3.8 brass and a 3/8 ID brass tube solderred on for a motor mont. Motor output averages approx. 35 watts based on 10 minute run time on a 480 mAh 3 cell LiPo.

Leading edge has a slight droop like GPW's Stealth Sport, Just formed it over the round edge of a formica counter top and then taped it with clear packing tape.

Assembly was done with hot glue.

Prop is an old Top Flight 6x4 Nylon.

CG is 12.5" back from where the nose is cut off. I need to try it farther back but it works.

Radio is a Hitec 3 channel as that is the only radio I ave with a mixer on board.

Dashed outlines are the original outline I sued, I cut the Nose off first to make the motor mounr shorter and then cut the fuselage profile down to get it to turn. It has been mentioned numerous times by others here on the Scratchbuilt forums that to much area ahead of the CG makes for problems turning and that was the case here.

I have posted it as letter sized tiled but managed to get 3 pages in as dups.

Last edited by kf2qd; Aug 04, 2007 at 05:20 PM.
Sign up now
to remove ads between posts
Dec 05, 2009, 11:40 AM
Registered User
many thanks.^^
Jun 06, 2011, 04:16 PM
Registered User
kangri's Avatar
how big is this

Thread Tools