DE-SWADJ Adjustable Switching Voltage Regulator - RC Groups
Thread Tools
May 28, 2007, 10:28 PM
Registered User

DE-SWADJ Adjustable Switching Voltage Regulator

I bought one of these. I've down loaded the pdf of the instructions. I can't for the life of me figure out how it works. I mean at the very simplest, most basic level I can't see how it is hooked up. HOW DOES IT WORK!!!!! Where does the battery connect to the voltage regulator? Then, how does that connect to the receiver/servos? I've converted and flown 20 planes. I've rigged the biggest Axi, Hacker and Neu motors with 15s power systems and I can't for the life of me figure out how this works. Why does Dimension Engineering have to make it so difficult? How about posting a simple photo of a fully rigged voltage regulator. I'd very much appreciate that bit of guidance. If not a photo how about dropping bread crumbs...
Sign up now
to remove ads between posts
May 29, 2007, 04:43 PM
Dimension Engineering
Its a voltage regulator in standard 7805 pinout. The three little pins at the bottom are what you connect to whatever you're powering:

GND should be shared between input and output.

Assuming that you're looking to use this as a BEC of some flavour, you'd attach your input battery wires to Vin and Gnd. Then you'd attach your output battery wires to Vout and Gnd. There should be two wires soldered to GND in this case.

However, if you're using it as a BEC, it would be MUCH easier to use our ParkBEC or SportBEC, unless you have an application that needs other than 5v or 6v. SW-ADJ is more general-purpose, at a cost of being harder to use.
May 29, 2007, 08:57 PM
Registered User
How about a photo?
Jun 02, 2007, 09:35 AM
Registered User
a photo might clear up any confusion for me or others out there.
Jun 03, 2007, 11:12 AM
Registered User
oK maybe a drawing, nothing fancy, back of an old envelope?
Jun 05, 2007, 10:49 AM
Cat lover
Here's a few example diagrams on how to use a DE-SW050 to power video transmitters. The SWADJ should operate in a similar way

With the SWADJ, you would have to use your multimeter to check the output voltage is set to the voltage you want

However using a SWADJ to power a receiver & servos isn't really an ideal match, and it would be better to use one of these products instead as they are specifically designed around powering receivers & servos with minimum wiring hassle
Jun 05, 2007, 10:04 PM
Registered User
Duh. I finally get it. Thank you so very much for posting these pictures. Where on earth did you find them? It would be so great if they would accompany your written directions or if they were available at your website. This is very helpful. Thank you.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale MODE1 JR6102(DX) with switching voltage regulator mod (double the stock runtime) cptsnoopy Aircraft - General - Radio Equipment (FS/W) 1 Jan 08, 2007 04:03 PM
Discussion PIC controlled adjustable voltage regulator tomskk DIY Electronics 12 Jan 10, 2006 07:22 AM
Sold ParkBEC switching Voltage Regulator Invertedflyby Aircraft - General - Miscellaneous (FS/W) 11 Dec 19, 2005 01:33 PM
Source for RX pack voltage regulator Ben Diss Power Systems 13 Jul 24, 2001 10:35 AM
Voltage Regulator wtghost1 Electric Ducted Fan Jet Talk 3 Jun 23, 2001 12:08 PM