Shop our Airplanes Products Drone Products Sales
Thread Tools
Mar 23, 2007, 10:23 AM
ProBro #1889
DsWright's Avatar
Discussion

what is the difference between these 2 frames?


what is the difference in this one: http://www.deeteeenterprises.com/NS....UpG.HS1107.php

vs. this one?
http://www.deeteeenterprises.com/NS....HS1137T-00.php

Any major difference besides one is 1/2 the cost?

looking to get direct to swash going on my T-rex XL.

thanks
Sign up now
to remove ads between posts
Mar 23, 2007, 11:10 AM
Registered User
Well, looks like the more expensive one comes with ali bearing blocks and tail supports as well as Aligns slightly changed ratio gears where as the cheaper one uses plasic blocks and doesn't have the gears, plus it's on sale.

Personally I've not got much experience in flying these as I've only just got a Falcon 3D but from what I've read the harder your heli is the more force goes into stripping servo gears. Points of weakness and flexability can be your friend...
Mar 23, 2007, 11:13 AM
JKY
JKY
Registered User
One is SE, the other is S/SA
Mar 23, 2007, 11:18 AM
ProBro #1889
DsWright's Avatar
Am i better off just buying the S Metal frame kit then? it's about the same $$...

now... Do the metal frame refitting components they sell replace all the plastic in the cheaper frame if i want to upgrade that later?
Mar 23, 2007, 12:29 PM
Conformity Kill's
IMO I would get the CF version over the alum. version. Yest the metal parts will replace the plastic ones if you want to upgrade later, but I think you save a few peenies if you bite the bullet and get the frame and alum bits together.

GW
Mar 23, 2007, 12:41 PM
ProBro #1889
DsWright's Avatar
I see you need to cut the CF frame for hs-56's and 65's...

do the 65's fit in the aluminum frame?
Mar 23, 2007, 01:10 PM
Conformity Kill's
you don't need to "cut", sometimes you need to file the rounded edges in the opening to fit the squared off edges of the servo, but you reall don't need to cut anything, a simple Xacto blade will shave the corners square. they will fit in the alum frame because thier stamped square.

GW
Mar 23, 2007, 02:35 PM
ProBro #1889
DsWright's Avatar
Quote:
Originally Posted by geneween
you don't need to "cut", sometimes you need to file the rounded edges in the opening to fit the squared off edges of the servo, but you reall don't need to cut anything, a simple Xacto blade will shave the corners square. they will fit in the alum frame because thier stamped square.

GW
Good info, thanks!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
What is the difference between these motors? louisd Power Systems 1 Sep 27, 2005 02:24 PM
What's the difference between these 2 batteries? Time Pilot GWS (Grand Wing Servo) 9 Oct 29, 2004 01:41 AM
What is the difference between these two GWS receivers ? robert harik GWS (Grand Wing Servo) 2 Mar 30, 2004 02:55 AM
what is the difference between these two GWS receivers? robert harik Radios 0 Mar 30, 2004 12:31 AM
What is the difference between these? Bill K. Batteries and Chargers 2 Nov 15, 2003 10:55 PM