Thread Tools
Old Mar 21, 2007, 01:01 PM
vtt is offline
vtt
Find More Posts by vtt
vtt
Registered User
Discussion

microheli cnc grips question/problem


hi

i have broken my blade cpp blade grips and replaced them with microheli cnc grips , since then my heli shakes hard at low rpm ( it flyes and hovers o.k).

trying to fix the problem i have already replaced the hub,blades and mainshaft.
tracking is good.

what am i missing here ?
where should i look ?
Sign up now
to remove ads between posts
Old Mar 21, 2007, 01:03 PM
PLATINUM is offline
Find More Posts by PLATINUM
Idle up!
PLATINUM's Avatar
another washer between the rubber dampener.
Old Mar 21, 2007, 01:30 PM
vtt is offline
vtt
Find More Posts by vtt
vtt
Registered User
thanks platinum , the problem is that it looks like the spindle is too short to fit 2 more washers (one for each side).

i'll try it and report back.
Old Mar 21, 2007, 01:58 PM
vtt is offline
vtt
Find More Posts by vtt
vtt
Registered User
platinum ,thanks again , you fixed my heli.
Old Mar 21, 2007, 03:31 PM
PLATINUM is offline
Find More Posts by PLATINUM
Idle up!
PLATINUM's Avatar
Glad to help


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
For Sale Blade CX MicroHeli CNC grips, center shaft & blades cobra command Aircraft - Electric - Helis (FS/W) 5 May 09, 2007 08:32 PM
Discussion MicroHeli CNC Upper Main Blade Grips chexone Coaxial Helicopters 1 Feb 02, 2007 09:28 PM
Radio Question, Problem? Teufel Hunden Radios 4 May 02, 2003 04:14 PM
MP Jet Gearbox Question/problem pval3 Sport Planes 9 Apr 17, 2002 11:05 PM