Thread Tools
Old Jan 18, 2007, 03:22 PM
MedcinMn is offline
Find More Posts by MedcinMn
Registered User
Question

How do I know when Lipos go bad?


Voltage? What can I do to test the batteries if I am having a performance problem (with the heli)?
Sign up now
to remove ads between posts
Old Jan 18, 2007, 03:25 PM
hall woo is offline
Find More Posts by hall woo
Permanently Banned
get a watt's up meter to sample and hold the readings
Old Jan 19, 2007, 03:15 PM
Red Scholefield is offline
Find More Posts by Red Scholefield
Molon labe
Red Scholefield's Avatar
Here is a tip I got from FMA.

1) Install the charged pack in the aircraft.
2) Set the CellPro to .25 A
3) Run the speed control to discharge the battery. Leave the charger and
12 volt power supply connected.
4) Watch the LCD or log it with the PC viewer. The PC Viewer software will
show a very nice graph of the discharge. If they wait until charge complete, the LCD only updates every 60 seconds. When charging, the LCD updates every second.

Nathan Gwozdecki
Design Engineer, FMA Inc.
Old Jan 19, 2007, 04:19 PM
hoppy is offline
Find More Posts by hoppy
Space Coast USA
hoppy's Avatar
First, is this a new performance problem? Did they work before?
What are the batteries? Brand, number, size?
Do you know the amp draw?
Which helicopter? Motor?

Buy a battery analyzer - CBA, Whatmeter meter, Hyperion meter, etc. Allows you to measure watts out over time.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Triton charger? how do i know when its done pipsta Batteries and Chargers 5 Mar 15, 2004 11:07 AM
How do I know if my Hummingboard is bad? kansasjayhawk Micro Helis 9 Nov 16, 2003 03:41 PM
Question Ni-Cad batteries, how do I know when they are fully charged gaseousfool Batteries and Chargers 7 Mar 05, 2003 09:18 PM