Thread Tools
Old Jan 03, 2007, 10:07 PM
mcf34 is offline
Find More Posts by mcf34
Registered User
Discussion

Toggle switch on BCX2 Transmitter purpose??


I know the knob on the right top of the transmitter is for the 5th Channel, but what is the toggle switch for on the left top of the transmitter for?? Is it the six channel? If so, is adding LED's as simple as getting some LED's at RS and then getting a wire with the correct connection type for the 4 in 1 and plug it/them into the 5th and 6th channels and go?
Sign up now
to remove ads between posts
Old Jan 04, 2007, 02:46 AM
aeronuts is offline
Find More Posts by aeronuts
Registered User
aeronuts's Avatar
Quote:
Originally Posted by mcf34
I know the knob on the right top of the transmitter is for the 5th Channel, but what is the toggle switch for on the left top of the transmitter for?? Is it the six channel? If so, is adding LED's as simple as getting some LED's at RS and then getting a wire with the correct connection type for the 4 in 1 and plug it/them into the 5th and 6th channels and go?
It is a 'trainer' switch. Two TXs can be connected together with a special cable, and the switch yields control to the other TX.

For instance, an experienced pilot can control on one TX for take-off and into stable flight, reliquish control to a newbie pilot on a connected TX to try flying it around a bit, and take over control again if the newbie gets into a tight spot.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question TRN switch on CX2 transmitter grapeflyer Coaxial Helicopters 1 Mar 01, 2007 11:45 PM
Wanted Toggle switch for JR transmitter djensen Aircraft - General - Radio Equipment (FS/W) 2 Feb 03, 2007 06:49 PM
Discussion Assigning a switch on a FF9 transmitter safesurfer Radios 1 Feb 14, 2006 03:53 AM
Can a toggle switch on my JR XP6102 be replaced with a proportional pot?? dgfisher2004 DIY Electronics 9 Nov 06, 2005 06:09 PM