Thread Tools
Aug 30, 2002, 03:49 PM
small electrics r BIG FUN

How do I hook 2 esc's into 1 receiver ?

Someday I'm gonna have to try my two Kontronik 400/22 and 3sl 25 Amp speed controls in the Twinjet. Using two speed controls should eliminate any worries about motors starting out of sync. So how do I get signal to both esc's ? Could it be as simple as using a "Y" servo extension ? That would be too easy.


Sign up now
to remove ads between posts
Aug 30, 2002, 03:53 PM
Registered User
Jurgen Heilig's Avatar
I have one on the normal throttle channel (CH1 for JR radio) and the other one on CH5. Three mixers do the rest - including differential throttle control via rudder channel. Jürgen
If you haven't got a computer radio, a Y-cable will do to, but you will miss out on a lot of fun.
Aug 30, 2002, 05:38 PM
Registered User
Andy W's Avatar
.. and disconnect the BEC from one of the ESC's by pulling the red wire pin (+ve) from the connector (and taping it up)..

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
How do you hook up 2 esc's? brianb10 Micro Helis 7 Sep 06, 2005 05:33 AM
How to build a A-10 with 2 BLīs & 1 ESC flyingfred GWS (Grand Wing Servo) 2 Oct 27, 2004 05:02 PM
3 BL Motors, 2 ESC's, 1 Gear Box Bill K. Aircraft - Electric - Airplanes (FS/W) 17 Apr 20, 2004 11:16 AM
How do I hook up 2 aileron servos? crashandburn Beginner Training Area (Aircraft-Electric) 6 Sep 09, 2003 09:48 AM
How do I hook up two brushless speed controllers to one receiver and battery? dom Foamies (Kits) 1 May 01, 2002 02:48 PM