LIPO Trick 2: Setting Up a LIPO VOLTAGE CLAMP - RC Groups
Thread Tools
Oct 13, 2006, 10:59 AM
Permanently Banned


Find the best swithcing regulator power supplies with the best wide range adjustment regulator board that has a ten-turn pot voltage adjust, most will only have a single turn pot adjustment

I use the 400W QUALIDYNE model no: 02003 F becuz it has a dualie 12V output at 7 amps and 15 amps monitored with whattmeters so I can read the ZERO charge current when done. I use this to charge 8 packs sometimes setup for 2S and 3S packs

I also found a 24V 4.2 amp switcher for a 6S pack ( 25.2V )

Using them is pretty simple: fly your lipo packs only ~70% duty cycle ( example, 40 amps instead of 56 amps on a TP 8000 7C gen 1 pack ) and charge them back up when the pack voltge is high, if U fly them too low then U will have to precharge them back up ~ 4V per cell using any charger with a CURRENT adjust

The output of a VOLTAGE CLAMP is set open circuit with no-load connected using a DVM or whattmeter

I would to hear about any other brands of swithchers like the QUALIDYNE made by Lamda
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion LIPO Trick #5: Slow Charging Using Voltage Clamps hall woo Batteries and Chargers 33 Oct 26, 2006 08:47 PM
ICE charger with lipo balancers (up/down voltage/current) Nethole Batteries and Chargers 3 Apr 02, 2005 08:03 PM
Question LVC setting for LiPo's AND NiMH dissimilar voltage packs? jbrundt Batteries and Chargers 1 May 06, 2004 08:59 AM
one slightly puffed up lipo in a 3 cell pack fwilly Batteries and Chargers 7 Jul 14, 2003 02:06 PM
Logo 10 Still setting it up after 2 months! Lv2Fly Electric Heli Talk 22 Oct 07, 2002 07:20 PM