Can we run two ail. servos and elev. on 3 chan. receiver ? - RC Groups
Thread Tools
Jun 29, 2001, 02:05 PM
Registered User
Lenny970's Avatar
Yes, it will work fine.
Good luck,
Sign up now
to remove ads between posts
Jun 29, 2001, 02:07 PM
Registered User
member73's Avatar
yes, the Y cable will work fine, just pay attention to the direction of travel for each servo before you install them.
Jun 29, 2001, 05:09 PM
EDF Head
Haldor's Avatar
Ditto - since the servo's are connected with a Y-harness sharing one rx outlet they are in parallell which the rx do not take notice of how many servo's there actually are. Tge rx will only see "one" and both will behave as one.

Jun 29, 2001, 06:20 PM
Registered User
Hi Al,

Yes, and if identical servos are fitted to each aileron as a mirror image of each other, then the orientation is fine.

Good luck with the Mad Dog,

Jun 30, 2001, 01:54 AM
small electrics r BIG FUN

Can we run two ail. servos and elev. on 3 chan. receiver ?

Can we use two servos for ailerons and one servo for elevator on a Hitec HS-3mb 3 channel receiver ?

Will this work with a y-adaptor for the two aileron servos so we still have channel 3 for throttle/esc ?

We are trying to use my son's 3 channel hitec SS 3 radio to fly his mad dog on ailerons, elevator, and throttle.

Any help is appreciated. Thanks