Anyone using parkflyer TowerPro servos? 5g and 9g - RC Groups
Thread Tools
Sep 08, 2006, 10:01 PM
Registered User
Discussion

Anyone using parkflyer TowerPro servos? 5g and 9g


Wondering about reliability and strength before I by a bunch of them.
Sign up now
to remove ads between posts
Sep 09, 2006, 06:05 AM
Sussex, UK
RobinBennett's Avatar
They are OK - I've got about 20 of the 5g servos and I've had one that didn't work properly and one that failed in the air but the others are fine. I trod on and broke some gears but was able to repair it with gears from the one that didn't work.

I've used them in a variety of small 3D planes, 40" and 52" zagnutz and a GWS spitfire.

I've only tried one 9g servo and there was a bit of slop in it - not enough to prevent me using it but more than you'd see in a higher quality servo. I've no idea if they all do that.

Basically I like them but wouldn't use them in anything really expensive or demanding.
Sep 09, 2006, 09:26 AM
Fighting Gravity
yamakawazuki's Avatar
I've got a few of the 9 gram servos, they work fine. I'm useing them in my e-starter, and my cub.
Sep 09, 2006, 04:46 PM
Suspended Account
Bilbobaker's Avatar
I have ten of them (5g) and they are about two years old and still working fine.
Bill


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Anyone using Draganfly 6 gram servos? Bob Veazey Radios 7 Sep 29, 2003 03:16 PM
anyone using GWS servos? Brian Courtice Slope 27 Jul 15, 2003 09:00 AM
anyone using JR 281 digital servos in a pylon racer? slammin High Performance 10 Jun 27, 2003 09:48 AM
Anyone using Hobbico CS-5 servos? R Shackleford Radios 0 Feb 25, 2003 11:13 PM
Is anyone using hitec flash 5 w/ 555 receiver and 55 series servos on a tiger moth The Other Dave Parkflyers 9 Nov 27, 2001 07:47 PM