How to make the button on a 9303 a momentary switch
I have been trying to figure out how to mix the trainer button on my 9303 into the rudder channel and have the button a momentary switch where you push it and it is on, let go and it is off. I can get it to be a push on/push off, but that won't work for what I want. Any ideas?
You should be able to assign the trainer switch to AUX4
For ACRO mode get into the setup menu ( power on + ENT)
-Scroll over to AUX4, press the scroll wheel, scroll to BUTN and select it with the scroll wheel.
- exit the setup and check AUX4 with the servo monitor.
It should move when you press the trainer switch.
- Now use a PMIX to mix AUX4 into the rudder.
In sailplane mode the method is similar, but some of the names and options in the DeviceSEL menu are different.
Hope that helps,
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||How to program the momentary switch on EVO9||Nicoflyer||Radios||3||Mar 13, 2007 06:00 AM|
|Question||How to program momentary switch on EVO9||Nicoflyer||Hitec/Multiplex USA||2||Mar 10, 2007 11:33 PM|
|Need Help On How To Make 3d Air Plane!||lttakas||Foamies (Kits)||31||Nov 03, 2003 12:44 AM|
|GWS pinon gear on upgrade motor. How to make "ridges" on drive shaft||Spiteful||Power Systems||5||Oct 07, 2003 03:45 AM|