No, it won't work.
That's a full size servo, and you need a micro servo.
You can tell because the HS-300 has four mounting holes, two on each side
. A micro servo only has two mounting holes, one on each side.
Here are some servos that are commonly used:
Volz Micro-Maxx "X" or "XP"
Multiplex Micro BB Digi
Basically, you need something about 1.2" by 0.5" by 1.2" or smaller with at least 30 oz/in of torque.
The most popular choice seem to be HS-85BBs for the cyclic and an HS-81 for the tail.
Adding to Toshi's info, wieght is also critical for EP heli of the ECO size. In fact I doubt a 300 would fit in the frame if it had to.
A standard servo like the 300 wieghs about 1.6 oz. A 85 goes at like .6 oz, so it saves 4 oz!!
But not all micro servos have 2 mounting holes. The JR 368 has 4 and it the same size as the 85.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Hitec RCD 3500 8-channel receiver, 4 HS-300 servos, 2 switches, 2 receiver batteries||geowiz||Aircraft - General - Radio Equipment (FS/W)||2||Jul 25, 2005 05:56 PM|
|Will HS-55 servos work with Multiplex Twin Jet?||Big Zoom||Electric Plane Talk||5||Sep 29, 2004 12:34 PM|
|BN2 Islander-Would HS-81 Servos work?||Mindblade||GWS (Grand Wing Servo)||2||Sep 28, 2003 09:45 AM|
|Will the Hitec HS-80 Servos work in the Litestick or Duskstik?||mrebman||Parkflyers||3||Sep 07, 2001 11:03 AM|
|Hitec 555 doesn't seem to work with my 8 UAF||Paul Susbauer||Electric Plane Talk||14||May 26, 2001 01:55 PM|