Thread Tools
Old Apr 29, 2006, 11:52 PM
spin-doc is offline
Find More Posts by spin-doc
LIGHT IT UP!
Discussion

Brushless data for GWS triple prop and quad prop.


Does anyone have an links or data on these props.
Better yet does anyone know how to guess on what kind of gearing you would need to anticipate the difference between a 9070 regular and the triple

How about the 1080 regular and the quad?

I figure the "scale" guys would be all over this.

Thanks from a scale prop wantabe.
Sign up now
to remove ads between posts
Old Apr 30, 2006, 06:21 AM
Smokin' Beaver is offline
Find More Posts by Smokin' Beaver
Registerd Beaver
Smokin' Beaver's Avatar
I can't answer all you Q's esp. the techo bits.
Can't say I've seen it but someone either here or the GWS board will have an answer.
What I have read & can verify is that if you go from a 2-blade prop to the same pitch in 3 blade, consider the 3 blade prop to have roughly +1" of pitch.
ie - it will load the motor up to the equivalent of what a 9080 2 blade prop would do.
It is because of the extra mass ( & a dozen other techo reasons to).
But I can vouch for the increase current draw.
As for practical use - I've found it no better than the 9070 2B, so my opinion is cosmetic value only.
No info on the 1080-4B sorry.

Phil
Old Apr 30, 2006, 10:40 AM
E-Challenged is offline
Find More Posts by E-Challenged
Registered User
E-Challenged's Avatar
I have flown the GWS 9x7 3-blade prop on my GWS Zero with a geared MIniAC1215/16 in a GWS 300C gearbox with C gearing. It pulled about the same as a 9X7 slow flyer prop. The 3 blades tend to break off or get damaged when/if you strike the prop on the ground. After quite some flying experience with small geared inrunners, I am beginning to think that the tiny front ball bearings are not able to cope well with the mass of large propellers and the jerking, pulling and pushing of the pinion against the spur gear. A cheap bushing as in brushed can motors might stand up better. I started a small inrunner versus small outrunner thread on the Electric Power forum to get other opinions. I think that for scale models, it's more practical to routinely fly with 2-bladers and display with good looking handmade scale props.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion **** Things you have been asking for:GWS CR Prop**** RAY GWS Product Announcements 17 Aug 16, 2007 04:21 PM
Discussion **** Things you have been asking for:GWS CR Prop**** RAY GWS GWS (Grand Wing Servo) 5 Jan 29, 2007 09:47 AM
Brushless motor for GWS Tiger moth curtqn Parkflyers 16 Aug 10, 2003 01:40 PM
Spinner for GWS 1080x4 Prop' AuzzieRCFlyer Parkflyers 5 Feb 16, 2003 10:06 PM
Anyone have Motocalc data for the GWS DX-A? rtideas Power Systems 0 Feb 18, 2002 03:07 PM