Next step towards Mubu's world domination - RC Groups
Thread Tools
This thread is privately moderated by biber, who may elect to delete unwanted replies.
Apr 19, 2006, 05:51 AM
Needs brain lubrication
biber's Avatar
Discussion

Next step towards Mubu's world domination


Yesterday we epoxied the RDS pockets and Servos into the wing.
Only the Pockets of the ailerons seem to extend the surface at about half a mm or so, still way nicer than any control lever could be .
This is going to be an overal sleek flyer .
The wing halfs are now glued together with some three degrees anhedral each side.
That should counteract the effective dihedral of the sweep and winglets.
Taped and waxed the PS core of the fuselage pod, then made the layup.
Maybe, if the shape of the prototype's pod works out ok, we will make a mold of it.
But for now it's just made for getting this thing airborn.

biber
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Yippee! Todd's Models - The Next Step Todd Long Parkflyers 19 Aug 21, 2005 04:33 PM
Question Aleron Trainer-next step after the s.s. BRIANRC Beginner Training Area (Aircraft-Electric) 10 Mar 11, 2004 11:01 AM
Next step after GWS Pico J3-F lowviz Parkflyers 4 Jun 10, 2001 03:25 AM
What transmitter for next step ?? JensJakob Electric Plane Talk 1 Jun 04, 2001 07:39 AM
$300 plane, $8 motor, WHat is the next step up? ezekiel Electric Plane Talk 11 Jun 02, 2001 02:37 PM