Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Oct 27, 2009, 09:56 PM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
Quote:
Is that the motor end? Why not put a uni there?
No room.

Quote:
folks have been using 'lock-tite #603'*
That's what probably had been used before.
Sign up now
to remove ads between posts
Old Oct 27, 2009, 10:08 PM
woodybob is offline
Find More Posts by woodybob
WooHoo!
woodybob's Avatar
Quote:
Originally Posted by Kmot
No room.
Pictures? Can you make a coupling? Is the motor inline with the shaft output?
Old Oct 27, 2009, 11:17 PM
tsenecal is offline
Find More Posts by tsenecal
Submarines, etc.
tsenecal's Avatar
kmot...

welcome to the club.

don't over torque the cable... you might have too much motor for the cable... you might want to drop down to a smaller prop....

rust is your enemy

and finally, hope this helps:

http://www.offshoreelectrics.com/inf...mble-shaft.php
Old Oct 27, 2009, 11:18 PM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
It's inline okay. I could get a new shaft and just stick it into the coupler. But, there definitely is no room for a uni.
Old Oct 28, 2009, 12:46 AM
Prop'er is offline
Find More Posts by Prop'er
Longhorn
Prop'er's Avatar
Hard Knoks College!


Almost there!
Last edited by Prop'er; Oct 28, 2009 at 01:03 AM.
Old Oct 28, 2009, 02:16 AM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
Love that propeller!
Old Oct 28, 2009, 03:23 PM
avidjeepr is offline
Find More Posts by avidjeepr
What is this a center for ants
avidjeepr's Avatar
That propeller should keep the mosquitos under control.
Old Oct 28, 2009, 08:57 PM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
The J-B Weld held. I was able to go full throttle and measure the power.
Old Oct 28, 2009, 09:13 PM
avidjeepr is offline
Find More Posts by avidjeepr
What is this a center for ants
avidjeepr's Avatar
It should hold till your in the middle of the lake.
Old Oct 28, 2009, 09:51 PM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
Most likely!
Old Oct 28, 2009, 10:00 PM
woodybob is offline
Find More Posts by woodybob
WooHoo!
woodybob's Avatar
Heh heh heh...
Old Oct 29, 2009, 06:01 AM
Bob Bighinatti is offline
Find More Posts by Bob Bighinatti
Registered User
Quote:
Originally Posted by Kmot View Post
hmmmmm............
Hi KMOT where did you get the batterys from ? all the hobby shops where I live sell VENOM and they are to much money . Thanks
Bob Big
Old Oct 29, 2009, 06:07 AM
nick_75au is online now
Find More Posts by nick_75au
NeverAgainVolunteerYourse lf
nick_75au's Avatar
Hi Kmot,
88 amps, that's very impressive for 1 motor, Its taken me four 700's to get to that level

Hi Bob,
Hobby king I reckon, banner at very top of RC groups, 3 people in our club have these batteries now, so far so good, the price is right too
Nick
Old Oct 29, 2009, 11:11 AM
Kmot is offline
Find More Posts by Kmot
Grumpa Tom
Kmot's Avatar
Quote:
Originally Posted by nick_75au View Post
Hi Kmot,
88 amps, that's very impressive for 1 motor, Its taken me four 700's to get to that level
Thanks Nick. Actually, it hit 98A yesterday during the quick full throttle test.

Bob, I got them from Hobby King as Nick thought.

I have also changed my Novak Smart Saver jumper wire from 16GA to a 12GA wire since yesterdays test. Might be a small benefit there.
Old Oct 29, 2009, 01:16 PM
HYDROJERRY is offline
Find More Posts by HYDROJERRY
Wave Riding Vehicles
HYDROJERRY's Avatar
hay Kmot, i see your running two bats at one time and you test with your watts up meter did you cut your wires to hook it up or does your set up have a connection between the two bats to the esc.i have a new wattsup but all my boats have two battery set up so to use it i would have to cut before my esc and install deans but i dont want to cause loss of power.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Video Hansen Dam Lake "Irregulars" Weekly Video Kmot Dock Talk 9 Feb 03, 2008 01:22 AM
Gallery Woodie on Hansen Dam Lake Kmot Dock Talk 13 Aug 12, 2006 04:27 PM
Gallery Micronaut's Amsterdam Tug @ Hansen Dam Lake Kmot Scale Boats 11 Mar 22, 2006 10:33 PM
Gallery More Hansen Dam Lake videos! Kmot Scale Boats 2 Mar 17, 2006 10:44 PM
Gallery Steve C.'s Corvette @ Hansen Dam Lake Kmot Scale Boats 2 Mar 17, 2006 08:23 PM