Thread Tools
Feb 13, 2006, 02:45 PM
Registered User
Discussion

Assigning a switch on a FF9 transmitter


Hi all

I need to assign a switch on my Futaba FF9 transmitter for the purpose of taking photos with an additional servo plugged into channel 8 or 9 on my 9 channel Futaba receiver.
Ideally one of the switches on the front left of the tranny.
Any idea on how its done as I can't make much sense of the manual.

Thanks

Mark
Sign up now
to remove ads between posts
Feb 14, 2006, 02:53 AM
Registered User
Daniel7866's Avatar
Switch ON.
Push mode/page for 2 seconds.
Turn right button to AUX-CH.
Push the button.
Arrows up/down to select channel.
Turn button to select switch/pot.
End.
End.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question TRN switch on CX2 transmitter grapeflyer Coaxial Helicopters 1 Mar 01, 2007 10:45 PM
Discussion Toggle switch on BCX2 Transmitter purpose?? mcf34 Coaxial Helicopters 1 Jan 04, 2007 01:46 AM
Snap Roll Switch on JR XP8103 KAMarks Hand Launch 2 May 24, 2002 08:26 AM
Can an arming switch on esc be bypassed? omega blood Power Systems 4 Feb 22, 2002 02:03 PM