Spacklesque filler before glassing? - RC Groups
Thread Tools
Feb 05, 2006, 02:21 PM
Nucking Futs
I'm Rick James's Avatar
Discussion

Spacklesque filler before glassing?


Got a foam wing that I need to glass here real soon and I dinged it in a few places getting aggressive with the sanding blocks. Ok fine, I chunked the foam in a couple spots!

Anyway, I wanted to know if you guys who glass regularly use something as a filler between the glass and the foam for instances like this or if you fill after the glass is layed on?

Thanks, RJ
Sign up now
to remove ads between posts
Feb 05, 2006, 02:34 PM
ave
ave
Wind Junkie
ave's Avatar
How about epoxy + lots of microballoon?

ave-
Feb 05, 2006, 04:47 PM
Registered User
timmig's Avatar
Spackle works--- be GENTLE!!!!
Feb 05, 2006, 04:57 PM
Nucking Futs
I'm Rick James's Avatar
OK, I'll give the spackle a go. I kinda figured the West Systems would get into it and make it sorta like microballoons anyway.

Thanks Tim and Ave.

RJ
Feb 05, 2006, 05:56 PM
Crikey never leave beer behind
steve wenban's Avatar
RJ I mix a little with water to thin the paste out as well its easier to apply also with a real thinned coat you can paint it on to a surface like balsa controls and works the same as dope and talc FWIW
SteveW


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Foam wing core "filler" before glassing I'm Rick James Composites Fabrication 8 Jul 15, 2005 10:45 AM