Multiplex FunJet - Page 461 - RC Groups
Thread Tools
Oct 27, 2008, 08:47 PM
Team Mulikow
Zeta30's Avatar
Quote:
As for which motor from hobbycity...no clue. I *LOVE* the ARC motors...faster than greased lightning...and can take serious power abuse.

-Eric
I must have gotten a bad one then. My ARC 28-37-2 went bad after about 20 flights. With the prop I had on it it was only at 40Amps static at WOT.
Sign up now
to remove ads between posts
Oct 27, 2008, 09:53 PM
LOVE MAIDEN'S : >
neiloneil's Avatar
Quote:
Originally Posted by Zeta30
I must have gotten a bad one then. My ARC 28-37-2 went bad after about 20 flights. With the prop I had on it it was only at 40Amps static at WOT.

man i hope this isnt typical of this motor its the one i got waiting to go in mine
Oct 27, 2008, 10:02 PM
Team Mulikow
Zeta30's Avatar
I always hear that you get what you pay for, that wasn't true at all with the ARC motor. I'm just going to stick with the cheap $20 motors. At least when they burn up it doesn't hurt the wallet quite as bad.
Oct 27, 2008, 11:29 PM
Registered User
GryphonRCU's Avatar
Zeta30,

Find out about ARC repair policy and cost.

Reputable companies always have a repair policy. If you can get your ARC repaired for same $20 or little more and that leaves you with a better motor than a $20 motor...you should do it.

Only issue will be the waiting time.


Gryphon
Oct 27, 2008, 11:30 PM
Not your average DiggsyBear
Diggs's Avatar
Zeta, did you contact Dave about your ARC motor? If not, you should try and see if he can help you out. The ARCs have to be some of the best I have run for their price. Have used the 2.5 short and 1.5 long can and am pretty amazed at the abuse they take. The long can 1.5 will take a lot of abuse with a 4S lipo and 80 amps. The Ritewing guys are slammin these motors and they take it no problem.

Diggs
Oct 27, 2008, 11:32 PM
Crash - Rebuild - Repeat
efether's Avatar
Quote:
Originally Posted by Zeta30
I must have gotten a bad one then. My ARC 28-37-2 went bad after about 20 flights. With the prop I had on it it was only at 40Amps static at WOT.
Not sure what to say to this....if properly cooled....this motor can go 6S or more. I've dozens of flights on this motor without issue. My ONLY issue is the shaft...I don't think it's tempered....so it bends (IMHO) too easily, but lightflight will sell you a replacement for 1/2 off...so I'm not complaining. Outside of the shaft issue....I've abused the h3ll out of this motor, and still love it.

-Eric
Oct 28, 2008, 12:05 AM
zoom zoom
gotboostedvr6's Avatar
Yeah i had my arc replaced and it took 40 days or so. But he did give me a brand new one for 1/2 so i cant itch too much.
Oct 28, 2008, 04:12 AM
Registered User
What would be faster, if I had to choose between these 2 motors? Mega 16/15/3 or 4? powered with 3s 2200 25c. I believe the '3' with 4.7x4.7 but not sure. I can go up to 40A.
Oct 28, 2008, 08:00 AM
Registered User
Ben D Wing's Avatar
Quote:
Originally Posted by Anasazi
What would be faster, if I had to choose between these 2 motors? Mega 16/15/3 or 4? powered with 3s 2200 25c. I believe the '3' with 4.7x4.7 but not sure. I can go up to 40A.
I am using the 16/15/3 in a very fast pylon race type model and using a 3s LiPo with an APC 5"x5" only draws 37 Amps (bench measurement) and gives just over 400 Watts (in) of power. These motors are very good quality and can be pushed further than what the manufacturer recommends and I think the '3' could easily cope with a 5.5"x5.5" for short bursts.
Oct 28, 2008, 08:55 AM
Team Mulikow
Zeta30's Avatar
Quote:
Originally Posted by Diggs
Zeta, did you contact Dave about your ARC motor? If not, you should try and see if he can help you out. The ARCs have to be some of the best I have run for their price. Have used the 2.5 short and 1.5 long can and am pretty amazed at the abuse they take. The long can 1.5 will take a lot of abuse with a 4S lipo and 80 amps. The Ritewing guys are slammin these motors and they take it no problem.

Diggs
I sent an e-mail off to lightflight this morning, will wait and see what they say.

For now I'm using a back up motor, a HeliMax inrunner I had in an old helicopter.
Oct 28, 2008, 09:05 AM
Registered User
Quote:
Originally Posted by Ben D Wing
I am using the 16/15/3 in a very fast pylon race type model and using a 3s LiPo with an APC 5"x5" only draws 37 Amps (bench measurement) and gives just over 400 Watts (in) of power. These motors are very good quality and can be pushed further than what the manufacturer recommends and I think the '3' could easily cope with a 5.5"x5.5" for short bursts.
Thanks. So it is as I have thought. Well, for now I'll try a Ray Inrunner with 2200 kv - should be something similar to 16/15/4 and see what will happen. If it is not enough for my FJ, than I have a ''copy'' of Gebhard Denon which should be happy to get this motor.



Oct 28, 2008, 10:19 AM
The Kid
Thekid3418's Avatar
holy crud! A built up pylon! haven't seen one of those in...my life time
Oct 28, 2008, 11:25 AM
Registered User
With a slow outrunner engine it is more a parkflyer / mini glider. I will be building a new one, with a ''faster'' airfoil and prepared for mounting the motor behind the firewall.
Oct 28, 2008, 08:17 PM
LOVE MAIDEN'S : >
neiloneil's Avatar
what timing just i put on my turnigy 60A esc with My ARC 28-37-2? i think default is low setting
Oct 29, 2008, 11:30 PM
The Kid
Thekid3418's Avatar
To anyone that is looking to make their funjet HAUL, i would suggest you look at this page

http://www.neumotors.com/2008/store/page10/page10.html

Towards the bottom is a neu 1112-2.5D which would make any funjet RIP! Its a 93% efficient motor! And its there for 50 bucks instead of the listed 135!!!! Just a thought for all those that want to go fast. This motor would be good on 4s or 5s and probably 80 amps or more in bursts!

Brian-addicted to neumotors


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Wanted Multiplex funjet ouluckydogu Aircraft - Electric - Jets (FS/W) 7 Jul 24, 2006 05:01 PM
Sold Multiplex Funjet NIB bruff Aircraft - Electric - Airplanes (FS/W) 4 Jul 06, 2006 05:46 PM
Video Multiplex FunJet - Full video (20 MB) Jeremy Z Electric Plane Talk 0 Jun 28, 2006 02:27 AM
Video Multiplex FunJET Indoor Jurgen Heilig Electric Plane Talk 2 May 01, 2006 07:31 AM