EZ fix for the Blade CX lower rotor head pivots
This is an easy fix for any of the many people here that have snapped the blade pivots off the lower rotor head.
Remove the lower rotor head piece from the heli and drill a 5/64 hole through the part were the blade holder stalks used to be.
Cut 2 pieces of 5/64 linkage wire approximately 3/8 long. I cut the pieces off a broken inner shaft instead of lingage wire.
Slide the lower rotor head back on and insert the wire into the holes. Use a small drop of thin CA at the base of the wire. Remove from outer shaft and let dry before re-installing.
It did this fix yesterday since it will be at least three more days until my replacement part came in. My BCX is back in the air and flying good!
Last edited by Velocity-8; Dec 19, 2005 at 04:00 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||how do you replace the lower rotor head on a axe ez?||howrd||Mini Helis||1||Jun 04, 2007 06:59 PM|
|Wanted||Lower Rotor for Blade CX||dasdef||Aircraft - Electric - Helis (FS/W)||3||Mar 18, 2007 06:37 AM|
|Discussion||Cx Lower Rotor Head Help||rolo||Coaxial Helicopters||4||Oct 29, 2006 08:18 PM|
|Discussion||Blade CX lower rotor head screws won't thread||theblade||Coaxial Helicopters||2||Oct 24, 2006 04:02 PM|
|Discussion||blade cx lower rotor head fix||anthony77||Coaxial Helicopters||2||Dec 30, 2005 08:26 PM|