Bad motor or bad speed control? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Dec 18, 2005, 08:34 AM
Registered User

Bad motor or bad speed control?

How do you determine if the motor went bad or if the speed controller went bad. I've had about 50 flights with my plane, and now it doesn't have enough power to take off. I have tried two different battery packs with the same results. The batteries work fine in my other plane.
Sign up now
to remove ads between posts
Dec 18, 2005, 09:43 AM
Italian Member
lombafly's Avatar
Motor brushless or brushed?
Dec 18, 2005, 09:51 AM
Tree Hater
zeuglodon's Avatar
If its a brushed motor it's probably the motor.
Dec 18, 2005, 09:52 AM
Senior User
Jeremy Z's Avatar
It is most likely a brushed motor, right?

The ESCs are solid-state; no moving parts, hardly EVER wear out unless abused.

Brushed motors on the other hand... They have carbon brushes which transport current to a rotating commutator into the armature. There is friction & arcing, which wear the brushes down. There are springs which feed the brushes into the commutator, but they can only make the brushes so long. So a point comes when the spring has fed the brushes as far as it is able, a gap between the commutator & brushes opens, there is more arcing, and less efficiency & power.

If it's a brushed motor, replace it. It'll probably cost you around $10. If that doesn't fix it, buy a new ESC, make sure it can handle the current the motor draws while running full throttle. Make sure the plane is not over-propped, so to speak.

Brushless motors would tend NOT to go bad, unless it is a bearing problem. There is no physical or electrical contact in a brushless motor to wear out. It works through pure electromagnetic induction. This means a longer life, and much higher efficiency due to lower friction. If you have a brushless motor, it is most likely the ESC.

Dec 18, 2005, 10:20 AM
Live to ride... and fly!
Tres Wright's Avatar
Usually when an ESC goes, it dies completely and you lose all motor control AND servo control. You probably just need to replace your motor. Or upgrade to a brushless and never worry about wearing out a motor again
Dec 18, 2005, 12:01 PM
lawn darts r' us
probably the motor. easisest way would be to swap motors with a known good speed control or vice versa, this way you can rule out the faulty component.

Speed controls are typically an all or nothing deal, they either work or they dont, In all my years in R/C (used to do high perf electric boats), ive never seen one 'loose power'.
Dec 18, 2005, 08:16 PM
Registered User
Thanks for all of the replies. The plane is a stock PZ Cub that I bought used on e-bay. A replacement motor is $10, while a replacement ESC/RX is $28. I took a chance and ordered a motor. Looks like I made the correct choice.
Dec 18, 2005, 08:53 PM
I'm dangerously carefree
SaMx's Avatar
yup, and a motor is usually cheaper to replace, at least if it's brushed. So if you have problems, changing the motor is usually the best bet.
Dec 19, 2005, 07:32 PM
(My website goes here)
johndreid's Avatar
I've had two cheap ESC/RX boards go bad after a crash...each one would run the motor wide open when a battery was attached.

Anyone ever heard of that?

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Dead motor or bad esc on Trex ivorz Mini Helis 5 Oct 08, 2006 10:57 PM
Help! Bad motor or ESC Slope Newbie Power Systems 6 Sep 04, 2006 12:34 AM
Discussion bad Motor or ESC ? Help! killedbyboredum Foamies (Kits) 4 Jun 19, 2006 12:13 AM
Help! bad motor or bad battery beginningdave Beginner Training Area (Aircraft-Electric) 3 May 14, 2005 04:11 PM
Bad luck or bad charger? JamesD Parkflyers 7 Mar 04, 2002 05:40 AM