FET failure charctaristics? - RC Groups
Thread Tools
Dec 15, 2005, 05:09 PM
Registered User

FET failure charctaristics?

Does anyone have any documentation or sources they can reccomend dealing with FET failures, how and why and what happens when they fail? The state they often fail in, maybe current charts or something?
Sign up now
to remove ads between posts
Dec 15, 2005, 06:09 PM
CamLight Systems
Mine have always failed by my overheating the junction, causing it to short. But, the short doesn't last long as the source resistor (for current sensing) usually vaporizes instantly and opens the circuit.

I would check http://www.irf.com (Intl. Rectifier) for more info. They have quite a few Application Notes and White Papers dealing with FETs.
Dec 15, 2005, 09:38 PM
Almost every failure is related to the design. Typically, people do not drive the gate with enough voltage (not current) to fully saturate the gate. Quite often, the input voltage is tied directly to the gate (P-Channel) and driven low to pass the source to the drain. The problem is that the gate requires a constant voltage and as batteries drop, the gate voltage drops below the required Vgs and is no longer fully saturated. This results in heat (extreme), causing failures. Other sources of failures include over-driving the gate with too much voltage, having too high of input voltage, and having too slow of switching speed between Vss and Vgs. As long as you stay within the limits of the part, and properly saturate the gate, a FET should never fail.
Last edited by JimDrew; Dec 15, 2005 at 09:46 PM.
Dec 16, 2005, 11:53 PM
Cat lover
In addition to what Jim and John have said, I'd like to chime in and mention something i've experienced with slow failing fets. When a FET is starting to fail for thermal reasons or whatever, its resistance increases. If you then reduce the load, you may never even realise the fet is half dead. But once you try to put a lot of current through it again, the increased resistance will result in a LOT more heat being generated in the fet, until it eventually completely fries.
Dec 17, 2005, 06:15 AM
Registered User
vintage1's Avatar
Thats right.

FETs fail in different ways to Biploars - there second breakdown and destrction of te vollector base junction is common.

With FETS you either get gate punch-through or severve modification of the doping levels and pattern in the channel.

Esenntially seminconductors are made with a semicinductor whose structure varies in space according to the dopant levels injected in those areas. Over time, the chemistry decays...at room temeperature te ageing is in decades, if not centuries..at temperatures about 200C its in hours, minurtes seconds or even less.

The FET gets 'old' very very quickly.

However its somewhat rare to see this - generally the FET is either working OK, or its dead.
Dec 17, 2005, 12:50 PM
แอนครู กรีน (เขียว)
C Andrew Green's Avatar
I was quite surprised when the SO8 (small 8 legged surface mount) FET failed in my MS (Jeti) brushed speed controller in a Hornet helicopter. I was flying around and thought that the batteries were sagging, when I landed and throttled back it just sat there revving because the poor little FET was done for! (short circuit source/drain) I held the model by the tailboom while a friend reached under and unplugged it (It's only a small heli). I replaced it with the equivalent part from International Rectifier and it has susequently flown loads more flights on 3 cel LiPos.