Thread Tools
Old Nov 30, 2005, 03:42 PM
icewater is offline
Find More Posts by icewater
Registered User

Servo torque for 3D plane?


How much torque do you really need on a 3d plane like the Hot rod mini or any other 7-10oz plane, bipe or single wing such as a 75% 3dbatix extra 330 (28" wing)?
I am looking at the AUW. I have been using the rc-Dymond D44's (weight 4.4g, 15oz torq) with very good results. I thought about the Blue bird 303 (3.6g with 10oz torq)
One more point, I normally use 2 servos for ailerons.
Any thoughts?
icewater
Sign up now
to remove ads between posts
Old Nov 30, 2005, 03:54 PM
spastic is offline
Find More Posts by spastic
ProBro Spaz
spastic's Avatar
on a 7oz plane 10oz torque is fine linkage setup makes the most difference, the dymonds are better servos however
Old Nov 30, 2005, 05:57 PM
Cubber is offline
Find More Posts by Cubber
Naturally altered
Right on, 10oz torque is fine for 7-10 ounces plane. I like the 5.4g GWS picos. I prefer a single servo installation for ailerons. When doing that, I will use a 7g 15-17oz torque servo for good measure.
Old Dec 01, 2005, 12:25 AM
savydad is offline
Find More Posts by savydad
Registered User
http://www.csd.net/~cgadd/eflight/calcs_servo.htm

Todd
Old Dec 01, 2005, 03:42 PM
icewater is offline
Find More Posts by icewater
Registered User
Thanks for the replys!
icewater


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New method for 3D plane connect, Look my DIY 3D plane. UNIX 3D / Fun Fly Fuel Planes 4 Aug 20, 2004 11:19 AM
Plans/ideas for 3D plane with airfoil for blucor? NewbieX 3D Flying 0 May 31, 2004 01:11 PM
Servo recom. for lrg plane crashed once by elev. flutter Brad B. Hitec/Multiplex USA 4 Apr 20, 2004 12:23 PM
looking for a 3d Plane kushal_22 Parkflyers 23 Jul 31, 2003 03:48 PM
Right thrust for 3D plane TrentO Sport Planes 6 Jun 24, 2003 07:17 AM