Zoom 400:- How do I fit the Canopy so it does not fall off? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Sep 25, 2005, 05:44 PM
Registered User

Zoom 400:- How do I fit the Canopy so it does not fall off?

Ok so it flys now so I am trying to fit the Canopy. I can see 2 pins sticking out the side of the side frames. Trouble is its not that secure. It looks a bit better if I put the Fuse on top of the battery tray but creates a problem with battery placement.

How do you guys fit the canopy?
Sign up now
to remove ads between posts
Sep 25, 2005, 06:43 PM
Old new guy
TheX's Avatar
I used rare earth magnets. Glued one to each pin and the inside of the canopy. They are VERY strong and small. Not sure where you might find them but I got them at Radio Shack in the US.
Sep 26, 2005, 02:17 PM
Registered User
Minimole's Avatar
You should have some little pins pointing outwards below where the battery goes (underside of frame, near the LG), and there should be a rectangle cut out of the bottom canopy, which slides just above the pins.
Bit hard to explain, hope you understand.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Zoom 400, 'must do' Mods? Brill 1 Mini Helis 4 Aug 02, 2004 12:33 AM
New micron 400. How do you fit everything???? argarre High Performance 1 Jul 16, 2004 06:55 PM
How do I fit a new pinion gear on the IPS motor ? Gaz Power Systems 0 Mar 10, 2004 07:14 AM
How do you make Hornet gear not wobble? Terkan Micro Helis 6 Nov 06, 2003 08:53 AM